Multifeeder Assembly; Pick-Up/Feeding System - Canon NP6085 Service Manual

4. MECHANICAL SYSTEM
III. PICK-UP/FEEDING
SYSTEM
A. Multifeeder Assembly
1. Removing the Multifeeder Assembly
1) Remove the rear upper right cover, rear right
cover, and upper right cover.
2) Remove the two screws, and remove the front
right cover.
3) Remove the two mounting screws q, and dis-
connect the two connectors w; then, remove
the multifeeder assembly.
Caution:
Be sure to mark the position of the multi-
feeder assembly with a scribe before
removing it.
Figure 4-301
4-32
COPYRIGHT © 1996 CANON INC.
q
w
2. Removing the Pick-Up Roller
1) Remove the multifeeder assembly.
2) Remove the multifeeder cover.
3) Remove the two mounting screws, and remove
the upper left cover.
4) Remove the two mounting screws q, and
remove the two multi shutter stoppers w.
1
5) Remove the three stop rings e at the front,
and remove the shutter r; then, remove the
pick-up roller t.
(Take care not to drop the parallel pin.)
4
CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
2
Figure 4-302
3 5
Figure 4-303