Control Card V - Canon NP6085 Service Manual

IV. INSTALLING THE

CONTROL CARD V

1) Remove the magnet plate.
2) Remove the control panel.
3) Remove the control card inlet face plate.
4) Remove the six screws q, and remove the
upper front cover.
q
Figure 5-5
5) Remove the seven screws q, and remove the
two screws e used to fix the grounding wire in
place; then, remove the wire saddle r, and
remove the metal plate.
e
r
w
Figure 5-6
COPYRIGHT © 1996 CANON INC.
w
w
CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
6) Remove the screw from the face plate t.
Figure 5-7
7) Remove the protection sheet from the display
of the Control Card V.
8) Fix the Control Card V to the control panel with
four screws y.
At this time, insert a card i into the Control
Card V u, and fix the Control Card V in place
where the card may be slid in and out smooth-
ly.
y
u
Figure 5-8
5. INSTALLATION
t
i
y
5-31