Canon NP6085 Service Manual page 294

3. OPERATIONS AND TIMING
Item Description
2SIDE_SL Use it to set stan-
dard settings for
two-sided (one-sided
to two-sided) copy-
ing.
FUZZY Use it to execute
fuzzy control and to
set environment set-
tings.
DENS_IND Use it to change the
copy density nota-
tion.
COPY_LIM Use it to set the
upper limit for the
copy count.
FIX_TEMP Use it to switch
among copying
sequences. (If fixing
faults occur, select 1
or 3.)
3-236
COPYRIGHT © 1996 CANON INC.
Settings
0: Select so that one-sided
copying is standard.
1: Select so that two-sided
copying is standard. (default)
You can control (fuzzy control)
the current applied to the pre-
transfer, transfer, or separation
charging assembly according to
ambient temperature. Or, you
can prohibit control to select 4-
point settings.
You can set the mode to be
enabled in response to a press
on the Reset key.
You can switch between 9-step
and 17-step notations for copy
density.
0: 9 steps (default)
1: 17 steps
Enter any number between 1
and 999.
Select so that the fixing temper-
ature is one of the following:
0: 155°C (default) 1: 160°C
2: 150°C 3: 165°C
CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
Remarks
Press '0' or '1' on the numer-
ic keypad.
0: Select to enable fuzzy
control. (default)
1: Select if images are too
light because of low
humidity.
2: Select if the ambient
humidity is normal.
3: Select if the cleaning sep-
aration claw and copy
paper come into contact
because of high humidity.
4: Select if '3' fails for high
humidity.
Press '0', '1', '2', '3', or '4' on
the numeric keypad.
Enter an appropriate number
on the numeric keypad.
Enter '0', '1', '2', or '3' on the
numeric keypad.