4. MECHANICAL SYSTEM
V. CHARGING
ASSEMBLY
A. Photosensitive Drum
1. Removing the Drum Unit
1) Open the front covers, and remove the pro-
cess cover.
2) Remove the mounting screw q, and discon-
nect the three connectors w; then, open the
LCD screen.
Figure 4-501
3) Remove the transfer charging dust-proofing
fan. (see p. 4-11)
4-64
COPYRIGHT © 1996 CANON INC.
2
1
CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
4) Disconnect the connector e from the toner
level detection PCB, and disconnect the faston
from the pole positioning plate.
4
Figure 4-502
Caution:
Be sure to hold the positioning plate with
fingers whenever pulling off the faston r of
the pole positioning plate. (Otherwise, the
pole positioning plate may come off the
cylinder shaft.)
5) Remove the two mounting screws t, and
remove the developing assembly duct y.
6
Figure 4-503
3
Red
Toner level sensor
5
5