Canon NP6085 Service Manual page 296

3. OPERATIONS AND TIMING
Item Description
DF_SIZE Use it to set original
size detection mech-
anisms for both AB-
and inch-configured
papers when using
the RDF.
ERASE Use it to select the
standard sheet
frame erasing func-
tion.
MRR_CONE Use it so that the
copier will know that
the C.F.F. mirror is
installed.
CFF_JAM Use it to delay jam
detection timing.
AE_SW Select the RDF or
the copier for AE.
3-238
COPYRIGHT © 1996 CANON INC.
5 USER OPTION
DF_SIZE : 0 (0:0FF,1:ON)
ERASE : 0 (0~2)
MRR_CONE : 1 (0:0FF,1:ON)
CFF_JAM : 0 (0:0FF,1:ON)
AE_SW : 0 (0:RF,1:PTN)
Screen 5-3
Settings
Both AB- and inch-configured
originals are checked for size
regardless of the country of
installation.
0: OFF (default)
1: ON
You can change the frame eras-
ing width for copy paper (lead-
ing edge, trailing edge, side).
0: 4, 2, 2.5 (default)
1: 4, 2, 0
2: 3, 1, 0
The copier cannot recognize the
presence of the C.F.F. mirror so
that you must force it to recog-
nize it in this mode.
0: C.F.F. mirror not connected.
1: C.F.F. mirror connected.
(default)
The holes in the continuous
paper is checked to detect a
jam in the C.F.F. Use this mode
so that the detection is in refer-
ence to all holes or sets of two
holes.
0: all holes
1: sets of two holes
Normally, use the RDF for AE; if
the RDF AE mechanism fails for
some reason, select copier AE.
CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
For example, if '1' is select-
ed, paper of the appropriate
size will be selected if an A4
or LTR original is copied
using the RDF-D1.
(unit: mm)
Be sure to select '1' if you
have connected the mirror.
0: RDF (default)
1: copier
Remarks