Canon NP6085 Service Manual page 251

Type of jam
Delivery delay
Delivery stationary
RDF open
Cover open
Pick-up signal
error
Initial original left
behind
Size error
Stream reading
fault
Error detection
COPYRIGHT © 1996 CANON INC.
Sensor
S5, S6 After S5 has detected an original, S6 does not detect an
original after feeding 218 mm in terms of length.
S6 S6 detects an original for 'feeding direction length x 1.5'
mm or more in terms of length.
S31 The RDF is opened during operation.
S13, S14 The right or left cover is opened during operation.
S23, S24
The pick-up command came from the copier when the
RDF is not ready for pick-up.
At the start of operation, an original is detected in the
paper path.
An L-size original is detected in image composition mode.
S20 1. In stream reading mode, the speed of the belt motor
(M3) is lower than specified when the leading edge of
the original reaches the point where exposure starts.
2. In stream reading, a command arrives from the copier
requesting of the belt motor (M3) to rotate at a speed
outside the possible range.
S17 In stream reading mode, the stop position of the advance
feeding ahead of the pre-registration is outside the possi-
ble range.
When a condition for E402, E403, E406, or E408 is
detected.
Note:
Such an error condition will be treated as a jam in the
RDF for the first three; thereafter, such a condition will be
treated as an error. This is to prevent issuing an error
when an original is damaged or placed improperly. The
count returns to '0' when the power switch is turned
OFF/ON.
Table 3-1006c (RDF)
CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
3. OPERATIONS AND TIMING
Description Code
25
26
E1
E2
E3
E4
E6
F4H
FEH
3-193