Canon NP6085 Service Manual page 36

1. GENERAL INTRODUCTION
2. Jams in the Fixing Assembly
1) Turn the fixing assembly knob, and remove the
jam.
Note:
The copier is designed so that the fixing
assembly cannot be slid out if paper is
straddling over the fixing assembly and the
delivery assembly. This is to prevent paper
from tearing.
2) Hold the grip, and slide out the fixing assembly
to the front.
3) Hold the grip, and open the separation claw
unit while pressing the lock releasing button.
Figure 1-28
4) Remove the paper trapped in the fixing assem-
bly.
5) Close the separation claw unit of the fixing
assembly.
6) Push in the fixing assembly to set it in the copi-
er.
7) Close the front door.
1-28
COPYRIGHT © 1996 CANON INC.
3. Jams in the Feeding Assembly
1) Hold the grip, and slide out the duplexing unit.
2) Remove the paper trapped in the feeding
assembly.
3) Push in the duplexing unit, and set it in the
copier.
4) Close the front door.
4. Jams in the No. 2 Feeding Assembly
1) Turn the knob on the registration roller, and
remove the jam.
2) Hold the grip, and slide out the duplexing unit.
3) Open the cover of the duplexing unit, and
remove the jam.
4) Push down the No. 2 feeding assembly, and
remove the jam.
5) Push in the duplexing unit to set it in the copier.
6) Close the front door.
CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 1-29
Figure 1-30