Removing The Power Supply Cord Mount - Canon NP6085 Service Manual

4. MECHANICAL SYSTEM
4) Remove the two screws, and remove
the transfer charging dust-proofing duct;
tap it above waste paper (copy paper)
so that it is free of residual toner.
Figure 4-132
5) Remove the screw, and remove the cap.
Screw
Figure 4-133
6) Pull out the transfer charging dust-proof-
ing duct 3, and tap it above waste paper
(copy paper). Then, clean the magnet
area with a moist cloth. (Check to make
sure that no droplet of water remains.)
Transfer charging dust-proofing duct 3
Figure 4-134
4-12
COPYRIGHT © 1996 CANON INC.
Screws
Transfer charging
dust-proofing duct 2
Cap
E. Removing the Power Supply
Cord Mount
1) Open the front door.
2) Remove the four mounting screws q, and
remove the power supply cover w.
2
1
3) Remove the buffer rear lower cover.
4) Disconnect the four connectors e, and
remove the two mounting screws r; then lift
the power cord mount assembly t slightly to
remove.
3 3
3
3
CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 4-135
Figure 4-136
1
4
5