Canon NP6085 Service Manual page 478

B. Installation to the Copier
Caution:
Observe the following when installing the
Card Reader-A1 to the copier:
1.Make sure that the copier has been prop-
erly installed.
2.Keep the copier's power plug disconnect-
ed for the work.
If the Power Supply-A1 is connected to
the Copy Data Controller-A1, disconnect
the Power Supply-A1 from the power out-
let.
3.Identify the screws by type (length, diam-
eter) and location.
1) Remove the magnet plate.
2) Remove the control panel.
3) Remove the inlet face plate of the Card
Reader-A1.
4) Remove the six screws q, and remove the
front upper cover.
q
Figure 5-62
COPYRIGHT © 1996 CANON INC.
5) Remove the seven screws w and the two
6) Remove the screw t from the face plate.
CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
screws e used to keep the grounding wire in
place; then, remove the wire saddle r and the
metal plate.
e
w
r
w
Figure 5-63
Figure 5-64
5. INSTALLATION
w
t
5-53