Canon NP6085 Service Manual page 472

Note:
1.If bit 4 of the DIP switch of the Copy Data
Controller-A1 is shifted to OFF, the nota-
tion will be as follows to indicate that
group control is not done:
Figure 5-48
2.If the copier's memory is used for ID No.
control, the existing ID Nos. may be used
for the Copy Data Controller-A1. Work as
follows:
Using Existing ID Nos.
a. Set the DIP switch (SW1) of the Copy Data
Controller-A1 as follows:
Bit
SW1
1 , 2
3
Table 5-6
b. Press the switch (SW4) on the Copy Data
Controller-A1.
LED5 turns ON instantaneously when the
switch is pressed.
c. When data has been drawn successfully,
LED5 turns ON.
If the attempt to draw data has failed, LED5
flashes. Press the switch (SW4) once again to
make sure that LED5 turns ON. The copier will
not discharge paper while data is being drawn.
d. Set the DIP switch (SW1) of the Copy Data
Controller-A1 as indicated. (LED5 will turn
OFF.)
Bit
SW1
1 , 2 , 3
Table 5-7
COPYRIGHT © 1996 CANON INC.
Setting
ON
OFF
Setting
OFF
CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
LED1 LED2 LED3
LED1 LED2 LED3
SW2
SW3
LED4 LED5 LED6
LED5
6 1 6 1
SW1 ON SW5 ON
SW1-3 SW1-2 SW1-1
Figure 5-49
5. INSTALLATION
JA1
JB2
JA2
JB1
SW4
SW4
5-47