6) Open the cleaning belt unit once again, and
open the cleaning belt feeding roller (right).
7) Lead the cleaning belt feeding roller y through
the two cleaning belt feeding rollers t; then,
close the cleaning belt unit after closing the
cleaning belt feeding roller (right).
5
Figure 4-825
8) Remove the cleaning belt feeding roller from
the cleaning belt unit.
9) With the upper separation claw unit u half
open, push the cleaning belt feeding roller i
through the gap.
7
Figure 4-826
COPYRIGHT © 1996 CANON INC.
6
8
CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
10)Open the cleaning belt unit, and open the
cleaning belt feeding roller (right).
11)Slide the cleaning belt pick-up roller o to the
rear, and remove it from the bushing at the
front; then, remove it from the bushing at the
rear.
Figure 4-827
12)Remove the cleaning belt from the cleaning
belt unit.
b. Installing the Fixing Cleaning Belt
Cleaning belt t unit (top view)
eaning belt feeding shaft (left)
Cleaning belt take-up roller
Cleaning belt feeding roller
(left)
Figure 4-828
4. MECHANICAL SYSTEM
9
Cleaning belt
feeding shaft (right)
Cleaning belt
roller
Cleaning belt feeding roller
(right)
4-91