Canon NP6085 Service Manual page 379

4. MECHANICAL SYSTEM
9) Disconnect the connector under the CW/CCW
rotation drive assembly; then, remove the
buffer assembly while shifting it up.
3. Removing the Duplexing Vertical Path Roller
1) Remove the vertical path unit. (p. 4-57)
2) Remove the four mounting screws q (2 pcs. at
front and rear), and remove the duplexing ver-
tical path roller cover w.
1
Figure 4-402
3) Remove the E-ring e, gear r, spacer t, two
E-rings y, spring u, and bushing from the
rear of the roller shaft.
8
Figure 4-403
4-58
COPYRIGHT © 1996 CANON INC.
1
2
6
7
5
4
3
CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
4) Remove the E-ring o and the bushing !0 ;
then, pull out the duplexing vertical path roller
!1 together with the shaft.
Figure 4-404
4. Positioning the No. 1 Paper Deflecting Plate
Drive Solenoid
Adjust the position of the solenoid so that the
No. 1 paper deflecting plate is as shown when the
plunger of the solenoid is pushed.
Figure 4-405
11
10
9
No. 1 paper
deflecting plate
No. 1 paper deflecting
plate drive solenoid