Canon NP6085 Service Manual page 365

4. MECHANICAL SYSTEM
5) Remove the three screws i (w/ hex hole), and
loosen the tensioner of the drive belt; then,
remove the drive gear 1 !0 toward the front.
10 8
8
Figure 4-357
6) Remove the mounting screw !1 , and remove
the slip stop !2 of the clutch. Remove the two
E-rings !3 , and remove the drive gear 2 !4
together with the drive belt.
(Be careful not to drop the parallel pin.)
14
12
11
Figure 4-358
4-44
COPYRIGHT © 1996 CANON INC.
9
8
13
7) Remove the two mounting screws !5 , and
remove the two float pins !6 .
8) Remove the E-ring !7 , and remove the bearing
!8 .
18
16
9) Open the front doors, and remove the pick-up
cover and the duplexing unit from the copier.
(p. 4-3)
10)Remove the two mounting screws !9 , and
remove the two float pins @0 .
11)Remove the C-ring @1 , and remove the gear
@2 .
CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
17
16
15
Figure 4-359