4
Disassembly/Assembly > Controller System > Removing the Power Supply PCB > Procedure
Removing the Power Supply PCB
■ Preparation
1) Remove the Rear Cover.(Refer to page 4-24)
2) Remove the Delivery Outer Cover.(Refer to page 4-29)
3) Remove the Left Cover.(Refer to page 4-27)
4) The Fax unit removes, and the installation is and removes the Fax unit in case of needing.
■ Procedure
1) Remove the Fixing Connector [1].
2) Remove the Power Switch Button Unit [1].
• 2 Screws [2]
• 1 Switch Alarm [3]
x2
4
Disassembly/Assembly > Controller System > Removing the Power Supply PCB > Procedure
[1]
F-4-111
[1]
[3]
[2]
F-4-112
3) Remove the Power Supply PCB [1].
• 3 Screws [2]
• 6 Connectors [3]
x3
x6
[3]
[2]
[3]
NOTE:
•
After installing the Power Switch Arm [1], be sure to check that the switch on the PCB
works by operating the Power Switch [2].
•
Be sure to set the Power Switch at OFF position.
[2]
[1]
[2]
F-4-114
4-62
[1]
F-4-113
4-62