Table of Contents
Advertisement
CMS Programming Basics
Once the CMS hardware and software are installed, you are ready to begin
programming CMS. This chapter and the next two chapters cover the
programming necessary to get CMS up and running with a single shift
configuration. Further programming is covered in the CMS Supervisor's
Guide.
This chapter describes the basics of CMS programming, including starting
CMS, moving between CMS screens, entering data, editing data, using the
help screens, and leaving CMS. These instructions apply to all CMS
programming and use. Refer to this chapter if you have questions while
entering data in the succeeding chapters.
Starting CMS
The first step in programming or using CMS is to start the program. The first
CMS screen that appears is the CMS Main Menu. This menu is the gateway
to CMS programming and to running call management.
Starting CMS
4-1
Advertisement
Table of Contents
Need help?
Do you have a question about the Call Management System and is the answer not in the manual?