Changing The Vdc 600 Board Dip Switch Setting - AT&T Call Management System Installation And Programming Manual

Installing the Hardware
Changing the VDC 600
Board DIP Switch Setting
IMPORTANT:
This procedure is required only for the 6300 WGS and 6286 WGS with
VGA graphics.
Configure the VDC 600 board (video controller board) for 8-bit video memory
data path and 8-bit BIOS. The DIP switches for the board are visible on the
back of the PC. To configure the board, complete these steps:
1. Turn PC off, if it is on, and wait for the hard disk to stop spinning.
2. Turn the PC to show the DIP switches on the VDC 600 card.
3. Move DIP switch 4 from the default ON position to OFF.
Figure 2-2 shows the required VDC 600 DIP switch settings.
Figure 2-2. VDC 600 DIP Switch Locations and Settings
DIP Switch
Settings for CMS
Installation Procedures 2-11