Assign Cms Lines, External Alerts, And Loop-Backs To Cms Supervisor - AT&T Call Management System Installation And Programming Manual

Programming the
Assign CMS Lines, External Alerts,
and Loop-Backs to CMS Supervisor
Before assigning all CMS outside lines or trunks—including those used for
CMS external alerts and loop-backs—to line buttons on the CMS supervisor's
telephone, remove any non-CMS lines or trunks that have defaulted to the
extension. The following procedure gives instructions for completing these
two tasks. To identify CMS lines or trunks, refer to Form 2c, System
Numbering—Trunk Jacks. To identify CMS line buttons, refer to Form 5a,
Direct Line Console (DLC)—Analog.
IMPORTANT
The order in which you add lines to the telephone determines the line
button assignments on the phone. For example, the first line you add is
assigned to line button 3, the second line is assigned to line button 4,
and so on. For this ordering to work, you must first remove all lines from
the phone (step 4).
Step
1. Display Assign
Lines/Trunks screen
2. Identify the CMS
supervisor's extension
and save entry
3. Select lines or trunks
— For logical IDs 1-20
— For logical IDs 21-40
— For logical IDs 41-60
— For logical IDs 61-80
Setting Up the Operator Positions
1-16
MERLIN LEGEND
System for CMS
MLX-20L
Extensions
LinesTrunks
Dial number
Enter
Lines 01-20
Lines 21-40
Lines 41-60
Lines 61-80
PC
[F6]
[F1]
Type number
[F10]
[F1]
[F2]
[F3]
[F4]