Installing The Cms Software - AT&T Call Management System Installation And Programming Manual

Installing the Software

Installing the CMS Software

CMS is provided on two types of diskettes:
Two 5.25-inch floppy diskettes, for use with the AT&T PC 6300 WGS
and AT&T PC 6300.
One 3.5-inch diskette, for use with the AT&T 6286 WGS.
Two sets of the CMS software are included—one working copy and one
backup copy. Use the working copy for installing the software. Store both
the working and backup copies in a safe place.
IMPORTANT
If this installation is an upgrade, refer to Appendix B for special instruc-
tions.
CMS comes with an auto-installation program that checks for adequate
memory and installs the program files. It also creates autoexec.bat and
config.sys files so that the CMS starts automatically whenever the PC is
turned on. (If these files exist, CMS modifies them, if necessary.)
To install the CMS program, complete the following steps:
1. Insert the working copy of the CMS software into drive A.
2. If the
A>
and press
The prompt should appear on the screen.
>
A
3. Type cmsinstall and press
The following message appears in the upper portion of the screen:
****Call Management System for the MERLIN LEGEND CMS
****Installation Procedure
This message remains on the PC screen throughout the installation procedure.
prompt does not appear on the computer screen, type a:
.
.
Installing the CMS Software 3-3