Setting Up Lines, Trunks, And Pools For Cms; Remove Cms Trunks, External Alerts, And Loop-Backs - AT&T Call Management System Installation And Programming Manual

Programming the MERLIN LEGEND
Setting Up Lines,
Trunks, and Pools for CMS
For CMS to function properly, all CMS lines or trunks must be assigned only
to the CMS PC and the CMS supervisor telephone. In addition, you must pro-
gram CMS channels in T1 lines for ground-start emulation. ISDN Primary
Rate Interface (PRI) lines require no special programming for CMS. The fol-
lowing sections give instructions for completing these tasks.
Remove CMS Trunks, External Alerts,
and Loop-Backs from Pools (PBX Only)
For a MERLIN LEGEND system operating in hybrid/PBX mode, make sure
that no CMS trunks are in the default pools. When a system is first set up, all
loop-start lines default to the Main Pool (extension number 70) while all
ground-start lines default to the pool with extension number 890. The follow-
ing procedure removes all CMS loop-start and ground-start trunks, external
alerts, and loop-back trunks that have defaulted to these pools. Refer to the
"Trunk Type" column on Form 2c, System Numbering—Trunk Jacks to iden-
tify loop-start and ground-start trunks.
Step
1.
Display Pools screen
2. Identify the pool and
save entry
3.
Select specific CMS
trunks
— For logical IDs 1-20
— For logical IDs 21-40

Setting Up Lines, Trunks, and Pools for CMS

1-10
System for CMS
MLX-20L
LinesTrunks
Pools
Dial pool dial-
out code
Enter
Lines 01-20
Lines 21-40
PC
[F4]
[F9]
Type pool dial-
out code
[F10]
[F1]
[F2]