Installing Ms-Dos - AT&T Call Management System Installation And Programming Manual

Installing the Software

Installing MS-DOS

Before installing the CMS software, you must install the MS-DOS software.
For a new system, installation includes formatting the hard disk, installing
MS-DOS, and setting the date and time. For an upgrade, installation requires
only installing MS-DOS 3.3, if necessary.
To install MS-DOS, complete the following steps. Have the MS-DOS manual
that came with the PC available for reference.
IMPORTANT:
If you are upgrading CMS from MERLIN II Release 2 CMS, do not com-
plete steps 3 and 4, unless you have backed up the files in the
CMSMGMT and CMSREPT directories and can restore them later. Steps
5 and 6 below are also optional for an upgrade.
1.
Locate the User's Guide: AT&T 6300 WGS Processor that came with
6300 WGS. The MS-DOS system diskette is in the envelope at the back
of the guide. If you are upgrading on a different system, locate the new
MS-DOS diskette. Keep the manual available for detailed information
on the following steps.
Insert the MS-DOS diskette into the computer.
2.
3. Create an MS-DOS partition using the entire hard disk.
4. Format the hard disk drive. Use the format command with the /
option to format the disk and copy the MS-DOS system files onto the
disk:
format c: /s
Install the MS-DOS programs onto the hard disk.
5.
Set the date and time for CMS operation and reports.
6.
Installing MS-DOS
3-2
the
S