Naming And Saving The Shift Configuration; Naming A Split Configuration - AT&T Call Management System Installation And Programming Manual

Building a Shift Configuration
CHANGE ALL-RING OPERATION: Split #:_
2. Enter the number of a split assigned All-Ring operation.
3. Press [F8] (Enter Data) to save the entry.
The prompt line disappears, the screen's function keys replace the editing
function keys, and the split's All-Ring setting on the Call Flow screen changes
from Off to On.
4. Repeat steps 1 through 3 for each split assigned AlI-Ring operation.
NOTE:
The No Ring option and the All-Ring option are mutually exclusive; when you
turn off the All-Ring option, you are not setting the No Ring option.
Naming and Saving
the Shift Configuration
The final step in building a shift configuration is to name it and save it. The
configuration's name appears on the Shift Configuration Planning Form.

Naming a Split Configuration

To name (or rename) a configuration:
1. If the Configuration Screen is currently displayed, press [F7] to return to
the Stored Shift Configurations screen.
2. Press [F3] (Rename Config).
The editing function keys replace the screen's function keys, and the following
prompt appears on the prompt line:
RENAME CONFIGURATION :
Config #:_

Naming and Saving the Shift Configuration

New Name:_______
6-13