Program T1 Lines - AT&T Call Management System Installation And Programming Manual

Programming the MERLIN LEGEND System for CMS

Program T1 Lines

If the MERLIN LEGEND system has 100D (DS1) modules with T1 lines to be
used by CMS, you must specify the emulation for each T1 channel. Channels
used for CMS must be programmed for ground-start emulation. To identify
lines, refer to the "Jack Type" column on Form 2c, System
DS1/T1
Numbering—Trunk Jacks.
NOTE:
Other channels in a T1 line not assigned to CMS may have other emulations.
Step
1. Identify the slot number
with the 100D module
and save entry
Specify T1 for the line
2.
type and save entry
3. Specify ground-start
emulation
— To select all channels
— To select some chan-
nels
4 . Identify channel(s) and
assign type
MLX-20L
LinesTrunks
GS/LS/DSl
Dial slot number
Enter
Type
T1
Enter
All Ground
Enter
Go to step 5
GroundStart
Enter
Dial channel
number
Enter
Setting Up Lines, Trunks, and Pools for CMS
PC
[F4]
[F1]
Type slot number
[F10]
[F1]
[F1]
[F10]
[F6]
[F10]
Go to step 5
[F1]
[F10]
Type channel
number
[F10]
1-13