Installing Loop-Backs - AT&T Call Management System Installation And Programming Manual

Installing the Hardware
5. Plug the video splitter into an AC outlet not controlled by a switch.
Figure 2-5 shows the connection between the video splitter, the PC, and the
two monitor cables.
To video port
To monitor 1
Figure 2-5. Connecting a View-Only Monitor

Installing Loop-Backs

The loop-back arrangement for an Automated Attendant or the Transfer-to-
Queue feature consists of a tip/ring station jack (on an 012 module) and a
loop-start line jack (on a loop-start module) connected by a single pair modu-
lar cord. Each loop-back requires one modular cord. Refer to Form 2a, Sys-
tem Numbering—Station Jacks and Form 2c, System Numbering—Line Jacks
for the jacks to be used for Transfer-to-Queue loop-backs.
NOTE:
Make sure that a ring generator is properly installed in the power supply, oth-
erwise CMS won't recognize the calls sent through the loop-back.
Installation Procedures
2-16
To AC outlet
To monitor 2