570 And 571 Printer Option Changes; Installing A View-Only Monitor - AT&T Call Management System Installation And Programming Manual

Installing the Hardware

570 and 571 Printer Option Changes

If the CMS is using the AT&T 570 or 571 printer, some of the default options
must be changed. The correct option settings for these printers are shown in
the following table. All the other options should retain the factory settings for
MS-DOS operation. Refer to the printer guide for instructions on how to
change these settings.

Installing a View-Only Monitor

Installing an optional second monitor requires a video splitter, video cabling,
and a second monitor. The video splitter connects to the video port on the
PC and the two monitors connect to ports on the video splitter. A single key-
board governs what appears on both monitors.
NOTE:
The view-only monitor works only with a VGA video adapter, such as an AT&T
VDC 600 video card or a built-in PS2 video port. It does not work with an
AT&T VDC 400 or AT&T VDC 750 video card, nor with the built-in video
adapters of the AT&T 6300 PC and AT&T 6300 Plus.
To install the video splitter and two monitors, complete these steps:
1. Connect the video splitter to the video port on the back of the PC.
2. Connect one end of a video cable to a port on the video splitter.
3. Connect the other end of the video cable to the monitor.
4. Repeat steps 2 and 3 for the second monitor.
Required Setting
Option
AUTO CR
BUF.FULL
AUTO LF
CR + LF
NO LF
CR + LF
Installation Procedures
2-15