Remove Cms Lines, External Alerts, And Loop-Backs From Telephones - AT&T Call Management System Installation And Programming Manual

Programming the MERLIN LEGEND System for CMS
— For logical IDs 41-60
— For logical IDs 61-80
4. Remove each CMS
trunk, external alert, and
loop-back from the pool
Exit to System Program-
5.
ming
Remove CMS Lines, External
Alerts, and Loop-Backs from Telephones
A MERLIN LEGEND system operating in key mode automatically assigns up
to 32 lines on telephone line buttons, depending on the type of telephone. In
hybrid/PBX mode, the system automatically assigns trunks to operator tele-
phones. If any of these lines or trunks are CMS lines or are used for CMS
external alerts or loop-backs, remove them from all telephones in a key sys-
tem and from all operator telephones in a hybrid/PBX system. (Make sure the
CMS lines are first removed from the default pools. See the previous pro-
cedure.)
In steps 1-5 below, you first remove CMS lines, external alerts, and loop-
backs from one agent phone (in a key system) or from one operator phone (in
a hybrid/PBX system). In steps 6-9, you copy the assignments from that
phone to other agent or operator phones. You cannot copy line assignments
between operator and non-operator phones in a hybrid/PBX system.
To identify CMS lines, external alerts, and loop-backs, refer to Form 2c, Sys-
tem Numbering—Trunk Jacks.
NOTE:
For any CMS lines or trunks connected to MERLIN LEGEND jacks above logi-
cal ID 32, you may skip this procedure. No lines or trunks above logical ID
32 default to telephones.
Lines 41-60
Lines 61-80
Press line but-
ton for each
trunk until red
LED is off
Exit
Exit
Setting Up Lines, Trunks, and Pools for CMS
[F3]
[F4]
Press function
key for each
trunk until letter
"R" is erased
[F5]
[F5]
1-11