Network Ap Selfheal Commands; Set - Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual

3.5.1 Network AP Selfheal set Command

set

Network AP Selfheal commands

Sets the different self-heal parameters.
Syntax
set [interference-avoidance|neighbor-recovery]
Parameters
interference-avoidance
[mode
[enable|disable] |
max-retries
[<max-retries>|default] |
hold-time
[<hold-time>|default]]
neighbor-recovery
[mode
[enable|disable] |
action <radio-idx> <action> |
offset <radio-idx>
[<offset>|default]]
Example - Set interference-avoidance:
admin(network.ap.selfheal)>set interference-avoidance mode enable
admin(network.ap.selfheal)>set interference-avoidance mode disable
admin(network.ap.selfheal)>set interference-avoidance max-retries 15
admin(network.ap.selfheal)>set interference-avoidance max-retries default
admin(network.ap.selfheal)>set interference-avoidance hold-time 24000
admin(network.ap.selfheal)>set interference-avoidance hold-time default
Example - set neighbor-recovery:
admin(network.ap.selfheal)>set neighbor-recovery mode enable
admin(network.ap.selfheal)>set neighbor-recovery mode disable
admin(network.ap.selfheal)>set neighbor-recovery action none radio 1
admin(network.ap.selfheal)>set neighbor-recovery action raise-power radio
1
admin(network.ap.selfheal)>set neighbor-recovery action open-rates radio
1
admin(network.ap.selfheal)>set neighbor-recovery action both radio 1
• mode [enable|disable] – Sets the self-healing interference mode. Can be
one of enable or disable.
• max-retries [<max-retires|default] – Sets the threshold limit on the
maximum number of retires permitted. <max-retires> (0-15) is the
number of allowed retries. default has a value of 14.
• hold-time [<hold-time>|default] – Sets the hold-time between running two
consecutive interference avoidance algorithms. <hold-time> (0-65535) is
the duration in seconds. default has a value of 3600.
• mode [enable|disable] – Enables or disables neighbor recovery.
• action <radio-idx> <action> – Sets the neighbor recovery action for the
portal. <radio-idx> (1-12) is the id of the radio for which action specified
in <action> must be taken. Select <action> from
open-rates, both.
Sets the radio offset value for the radio <radio-idx> (1-12) when the set
action is raise-power. <offset> value is between 0-65535. default value is
0.
Network CLI Commands Reference
none, raise-power,
3-25