System Snmp Access Commands; Access; Add - Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual

4-72 WS2000 Wireless Switch System Reference Guide
4.17.1 System SNMP Access add Command

add

System SNMP Access Commands

Adds SNMP access list entries.
Syntax
add [acl|v1v2c|v3]
add acl <ip1> <ip2>
add v1v2c <comm> <access> [<oid>|all]
add v3 <user> <access> [<oid>|all] <sec> <auth> <pass1> <priv> <pass2>
Parameters
add acl <ip1> <ip2>
v1v2c <comm>
<access> [<oid>|all]
v3 <user> <access>
[<oid> / all] <sec>
<auth> <pass1> <priv>
<pass2>
Example
admin(system.snmp.access)>add acl 209.236.24.1 209.236.24.46
admin(system.snmp.access)>list acl
----------------------------------------------------------------
index start ip
----------------------------------------------------------------
1 209.236.24.1
admin(system.snmp.access)>add v3 fred rw 1.3.6.6 none
admin(system.snmp.access)>list v3 all
Adds an entry to the SNMP access control list with <ip1> as the starting IP
address and <ip2> and the ending IP address.
Adds an SNMP v1/v2c configuration.
• <comm> – The community
• <access> – The read/write access set to
• <oid> – The Object Identifier. <oid> is a string of 1–127 numbers in dot
notation, such as 2.3.4.5.6 or
Adds an SNMP v3 user definition.
• <user> – The username
• <access> – The read/write access set to
• <oid> – The Object Identifier. <oid> is a string of 1–127 numbers in dot
notation, such as 1.3.6.1 or
• <sec> – The security type. <sec> is set to one of none, auth, or auth/priv.
The following parameters must be specified if <sec> is set to auth/priv:
• <auth> – The authentication algorithm. Can be one of
be set if <sec> is set to
• <pass1> – The password
provided if <sec> is set to
• <priv> – The privacy algorithm. Set to
set to auth/priv.
• <pass2> – Privacy password
is set to auth/priv.
end ip
209.236.24.46
(1–31 characters)
(ro (read only) or
all for all objects.
(1–31 characters).
ro (read only) or
all for all objects)
auth or auth/priv.
(8–31 characters) for authentication. Must be
auth or auth/priv.
des or aes. Must be set if <sec> is
(8–31 characters). Must be provided if <sec>
rw (read/write)
rw (read/write)
md5 or sha1. Must