3.47 Network WIPS Default commands
defaults
Network WIPS Command
Goes to the WIPS default configuration menu.
Syntax
admin(network.wips)>defaults
admin(network.wips.defaults)>
The items available under this command are shown below.
Default
show
set
quit
save
..
/
Shows the WIPS default configuration settings.
Sets the Sensor default configuration for WIPS.
Quits the CLI.
Saves the configuration to system flash.
Goes to the parent menu.
Goes to the root menu.
Network CLI Commands Reference
Description
3-245
Ref.
page 3-247
page 3-246
page 3-1
page 3-1
page 3-1
page 3-1