Setup And Operation; Booting The Apex1000; Security Requirements; Establishing Network Connections - Motorola APEX1000 Installation And Operation Manual

4
Configuring the APEX1000
To configure the APEX1000, you must use the Element Manager (APEX1000 EM). For
more information on downloading and activating this application, see the
Requirements

Booting the APEX1000

The APEX1000 supports the BOOTP protocol.

Security Requirements

To configure the APEX1000, you must use the Element Manager (APEX1000 EM). For
more information on downloading the Element Manager, see

Establishing Network Connections

At power up, the operating configuration of the APEX1000 is determined by data stored
internally in flash memory, or by data that is downloaded from a bootstrap protocol
(BOOTP) server; the particular method used to set up initial operation depends on the
system configuration.
After setting the initial operating configuration, modify the configuration by:
•
Sending commands from an SNMP network manager (such as the APEX1000 EM)
•
Forcing a reboot to download a new configuration to the APEX1000 from the BOOTP
server. The APEX1000 only processes BOOTP responses from the OAM&P interface
(ENET1)
Note: The MAC addresses for the four GigE ports and the two Ethernet ports are listed
on the serial number label, attached to the bottom of the APEX1000.
Setup and Operation • Booting the APEX1000
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a

Setup and Operation

section of this guide.
APEX1000 EM
Downloading the JRE.
B
40