Set - Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual

3-88 WS2000 Wireless Switch System Reference Guide
3.17.1 Network LAN set Command

set

Network LAN Commands
Sets the LAN parameters for the six subnets.
Syntax
set [ipadr|mask|dgw|mode|name|port|wlan|stp]
set ipadr <idx> <ip>
set mask <idx> <netmask>
set dgw <idx> <ip>
set mode [enable|disable]
set name <idx> <name>
set port <port> <subnet>
set wlan <wlan> <subnet>
set stp <mode>
Parameters
ipadr <idx> <ip>
mask <idx> <netmask>
dgw <idx> <ip>
mode <idx>
[enable|disable]
name <idx> <name>
port <port> <subnet>
wlan <wlan> <subnet>
stp <mode>
NOTE: STP is applied on mesh networks even if it is disabled through the
command.
Example
admin(network.lan)>show lan 1
subnet name
subnet interface
ip address
network mask
ports
wlans
Sets the IP address of subnet <idx> (1–6) to the IP address <ip> in the form
a.b.c.d.
Sets the netmask of subnet <idx> (1–6) to IP address mask <netmask> in the
form a.b.c.d.
Sets the default gateway for the subnet <idx> (1-6) to the IP <ip>.
Enables or disables the subnet identified by <idx> (1–6).
Sets the name of the subnet <idx>(1–6) to <name> (can be up to 7 characters).
Assigns port <port>(1–6) to the subnet indicated by <subnet> (none, s1, s2,
s3, s4, s5, s6). Unassigns a port with <subnet> = none.
Assigns WLAN number <wlan> to the subnet indicated by
s4, s5, s6). Unassigns a WLAN with <subnet> = none.
Enables or disables Spanning Tree Protocol (STP) for the subnets. Choose
<mode> from enable or disable.
: Subnet1
: enable
: 192.168.0.1
: 255.255.255.0
: port1 port2 port3 port4 port5 port6
: wlan1
(none, s1, s2, s3,
set