Add - Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual

3.28.1 Network WAN VPN add Command

add

Network WAN VPN Commands
Adds a security policy database (SPD) entry.
Syntax
add <name> <LSubnet> <LWANIP> <RSubnetIP> <RSubnetMask> <RGatewayIP>
Parameters
<name> <LSubnet> <LWanIP> <RSubnetIP> <RSubnetMask> <RGatewayIP>
Creates a tunnel named <name>
(1, 2, 3, 4, 5, 6), through local WAN IP <LWanIP> from the remote subnet with address
<RSubnetIP> and subnet mask <RSubnetMask> using the remote gateway <RGatewayIP>.
The local WAN IP can be set to 0.0.0.0 for a DHCP client. Any IP address obtained from the DHCP
server is then used to initiate the VPN tunnel. The VPN peer must set it's Remote Gateway
address to 0.0.0.0 to indicate an IP value of ANY and shall operate as a responder only.
Example
admin(network.wan.vpn)>add Bob 1 209.239.160.55 206.107.22.45
255.255.255.224 206.107.22.2
If tunnel type is Manual, proper SPI values and Keys must be configured
after adding the tunnel
admin(network.wan.vpn)>list
------------------------------------------------------------------------
Tunnel Name
Subnet
-------------------------------------------------------------------------
Eng2EngAnnex
1
Bob
1
admin(network.wan.vpn)>
(1
Type Remote IP/Mask
Manual 192.168.32.2/24
Manual 206.107.22.45/27
Network CLI Commands Reference
to 13 characters) to gain access to local subnet <LSubnet>
Remote Gateway
192.168.33.1
206.107.22.2
3-145
Local WAN IP
192.168.24.198
209.239.160.55