Network Ap Default Commands; Default - Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual

3.3 Network AP Default Commands

default

Network AP Commands
Displays the default Access Port (AP) submenu. Use these commands to set the default values for all APs.
Syntax
admin(network.ap)> default
The items available under this command are shown below.
Command
set Sets default Access Port parameters.
loadfromcf Loads the configured images from the CF card immediately
show Shows default Access Port parameters.
quit Quits the CLI.
save Saves the configuration to system flash.
.. Goes to the parent menu.
/ Goes to the root menu.
The items in this menu are available in the Web interface under the three default Access Port screens (one
for each radio type) within the Wireless menu area.
Description
Network CLI Commands Reference
Ref
page 3-18
page 3-20
page 3-21
page 3-1
page 3-1
page 3-1
page 3-1
3-17