Add - Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual

3.45.1 Network IP Filter add Command

add

Network IP Filter Commands
Adds an entry into the global IP Filter table.
Syntax
add <filter-name> <protocol> <port> <start-src-address> <end-src-address>
<start-dest-address> <end-dest-address>
Parameters
add <filter-name> <protocol> <port> <start-src-address> <end-src-address> <start-dest-address> <end-
dest-address>
Adds an IP Filter with <filter-name> to the IP Filter table.
• <protocol> can be one of
ipv6, compr_h,
• <port> is the port number. Could also be all.
• <start-src-address> to <end-src-address> is the source ip range for which this filter is applied
• <start-dest-address> to <end-dest-address> is the destination ip range for which this filter is
applied.
Example
admin(network.ipfilter)> add port80tcp TCP 80 192.168.1.100 192.168.1.250
0.0.0.0 0.0.0.0
admin(network.ipfilter)> show
-------------------------------------------------------------------------
Filter-Name
In-Use
-------------------------------------------------------------------------
allow_tcp
YES
allow_udp
NO
port80tcp
NO
tcp, udp, icmp, pim, gre, rsvp, idp, pup, egp, ipip, esp, ah, igmp,
raw_ip.
Protocol-Port
TCP
ALL
UDP
ALL
TCP
80
Network CLI Commands Reference
Start-End-Src-IP
0.0.0.0 0.0.0.0
0.0.0.0 0.0.0.0
0.0.0.0 0.0.0.0
0.0.0.0 0.0.0.0
192.168.1.100 0.0.0.0
192.168.1.250 0.0.0.0
3-235
Start-End-Dst-IP