Insert - Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual

3.14.3 Network Firewall Policy Inbound insert Command

insert

Network Firewall Policy Inbound Commands
Inserts a new firewall policy before an existing policy.
Syntax
insert <idx> <sip> <snetmask> <dip> <dnetmask>
Parameters
<idx> <sip>
<snetmask> <dip>
<dnetmask>
Example
admin(network.fw.policy.inb)>list
-------------------------------------------------------------------------
Idx Src IP-Netmask Dst IP-Netmask Tp SPorts DPorts Rev. NAT
-------------------------------------------------------------------------
1 209.239.170.88- 192.168.42.2- all 1:
255.255.255.224 255.255.255.0
admin(network.fw.policy.inb)>insert 1 209.239.160.44 255.255.255.224
192.168.55.
44 255.255.255.0
Inbound Policy Successfully inserted at index 1
admin(network.fw.policy.inb)>list
-------------------------------------------------------------------------
Idx Src IP-Netmask Dst IP-Netmask
-------------------------------------------------------------------------
1 209.239.160.44- 192.168.55.44- all 1:
255.255.255.224 255.255.255.0
2 209.239.170.88- 192.168.42.2-
255.255.255.224 255.255.255.0
Inserts a new policy into the inbound firewall policy list at a specified index.
• <idx> – The index in the firewall policy list where this policy is to be inserted.
• <sip> – The source IP
• <snetmask> – The source IP's network mask
• <dip> – The destination site IP
• <dnetmask> – The destination IP's network mask
Tp SPorts DPorts Rev. NAT
all 1:
Network CLI Commands Reference
1: 0.0.0.0
65535 65535 nat port 0
1: 0.0.0.0
65535 65535 nat port 0
1: 0.0.0.0
65535 65535 nat port 0
3-69
Action
deny
Action
deny
deny