Add - Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual

3.16.1 Network Firewall Submap add Command

add

Network Firewall Submap Commands
Adds subnet access exception rules.
Syntax
add <from> <to> <name> <tran> <port1> <port2>
Parameters
add <from> <to>
<name> <tran>
<port1> <port2>
Example
admin(network.fw.submap)>add s1 w test gre 21 101
admin(network.fw.submap)>list s1
-------------------------------------------------------------------------
index from
-------------------------------------------------------------------------
1 subnet1 wan
admin(network.fw.submap)>add s1 s2 test2 ah 20 80
admin(network.fw.submap)>add s2 s3 test3 all 20 300
admin(network.fw.submap)>list s1
-------------------------------------------------------------------------
index from
-------------------------------------------------------------------------
1 subnet1 wan
2 subnet1 subnet2 test2
Adds a subnet access exception rule for communication.
• <from> – The source subnet (one of
subnet2,
subnet6)
• <to> – The destination subnet (one of
subnet2,
subnet6, w=WAN)
• <name> – The name of this exception rule.
• <trans> – The transport protocol to deny access. (one of
the following transport protocols: tcp, udp, icmp, ah,
esp, gre, or all)
• <port1> <port2> – Ports in the range <port1> to
<port2>
to name prot
test gre
to name prot
test gre
ah
Network CLI Commands Reference
s3 = subnet3, s4 = subnet4,
s3 = subnet3, s4 = subnet4,
(1-7 characters)
start port
21
start port
21
20
3-81
s1 = subnet1, s2 =
s5 = subnet5, s6 =
s1 = subnet1, s2 =
s5 = subnet5, s6 =
end port
101
end port
101
80