4.2.1 System Authentication set Command
set
System Authentication Commands
Sets the parameter that specifies how user authentication is taking place.
Syntax
set [mode|auth-loc] [local|radius]
Syntax:
set mode [local|radius]
set auth-loc [local|radius]
Example
admin(system.authentication)>set mode local
admin(system.authentication)>show all
authentication mode
admin(system.authentication)>
Related Commands
set
Sets the parameters to specify that the external RADIUS server is used for user
authentication.
Sets the authentication mode. If set to local, the internal User Database will
serve as the data source. If set to radius, the switch will use an external
LDAP server for the information. If
under the
radius
submenu must to be set.
Sets the Airbeam user authentication to either the local database or the
RADIUS server. If set to radius, the switch will use an external LDAP server
for the authentication. If
radius
RADIUS server is used for authentication.
: local
System CLI Commands Reference
radius
is the mode, then the parameters
is the authentication location, then the
4-5