Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual page 17

|
[ ]
{ }
values
The pipe symbol. This is used to separate the variables/keywords in a list.
For example, the command
admin(network.wan.vpn)> set .....
is documented as
set [ike|type|sub|remip|......]
where:
• set – The command
• [ike|type|sub|remip|...] – Indicates the different commands that can be combined with
the set command. However, only one of the above list can be used at a time.
set ike ...
set type ...
set sub ...
set remip ...
Of the different keywords and variables listed inside a '[' & ']' pair, only one can
be used. Each choice in the list is separated with a '|' (pipe) symbol.
For example, the command
admin(network.wan)> show ...
is documented as
show [ip|pppoe]
where:
• show – The command
• [ip|pppoe] – Indicates that two keywords are available for this command and only one
can be used at a time
Any command/keyword/variable or a combination of them inside a '{' & '}' pair
is optional. All optional commands follow the same conventions as listed
above. However they are displayed italicized.
For example, the command
admin(network.wan.vpn)> list ....
is documented as
list {<name>}
Here:
• list – The command. This command can also be used as
list
• {<name>} – The optional variable <name>.. The command can also be extended as
list vpn_tunnel_01
Here the value vpn_tunnel_01 is an optional tunnel name.
Values to be entered as shown in Blue.
For example, the command
admin(network.wan)> show ip ....
is documented as
show ip <idx>
This command's parameter <idx> is described as under:
"<idx> – <idx> (1-8) is the Wlan Index."
1-3
Product Overview