Network Wlan Rogue Ap Commands; Set - Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual

3-182 WS2000 Wireless Switch System Reference Guide
3.32.1 Network WLAN Rogueap set Command

set

Network WLAN Rogue AP Commands

Sets rogue access point parameters.
Syntax
set [muscan|apscan|detscan|fullapscan] [mode <mode>|interval <interval>]
Parameters
[muscan|apscan|detscan|fullapscan] [mode
<mode>|interval <interval>
Example
admin(network.wlan.rogueap)>set apscan mode enable
admin(network.wlan.rogueap)>set apscan int 60
Related Commands
show Displays the rogue AP parameters.
Sets the different Rogue AP parameters
• muscan – Sets MU scanning parameters
• apscan – Sets AP scanning parameters.
• detscan – Sets Detector scanning parameters. For
this feature to work, you must set one of the
Access Ports as a Detector AP.
• fullapscan – Sets full AP scanning parameter. For
this feature to work, you must set one of the
Access Ports as a Full Detector AP.
Each of the above options have these settings
• mode <mode> – <mode> can be
disable. Use this to enable or disable a rogue ap
parameter
• interval <interval> – Sets the scanning interval for
rogue ap detection. <interval> can be between
to 65535 minutes. For fullapscan, the interval is
in seconds.
Enables or disables mobile unit scanning.
enable or
5