Set - Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual

3-18 WS2000 Wireless Switch System Reference Guide
3.3.1 Network AP Default set Command

set

Network AP Default Commands
Sets the default Access Port parameters.
Syntax
set [beacon|ch_mode|div|dtim|primary|reg|rate|rts|short-pre|sensor-img|
ap4131-img|ap4121-img]
Parameters
beacon intvl <type>
<interval>
ch-mode <type>
[fixed|random|auto]
div <type> <mode>
dtim <type>
[<bss_idx>|<period>]
primary <type> <wdix>
rate <type> <basic>
<supported>
reg <type> <indoor> <ch>
<pwr>
rts <type> <bytes>
Sets the default beacon interval for specified radio type <type> (one of
802.11a, 802.11b, or 802.11b/g) to <interval> in K-us (50–200).
Sets the default channel mode for radios of <type> (one of 802.11a, 802.11b,
or 802.11b/g) to fixed, random, or auto.
Sets the default antenna diversity for radios of <type> (one of 802.11a,
802.11b, or 802.11b/g) to <mode> (one of full, primary, or secondary).
Sets the default DTIM period for radios of specified <type> (one of 802.11a,
802.11b, or 802.11b/g) to <period> number of beacons (1–50).
<bss_idx> is the index of the BSSID. If not specified for the AP300, the
default value of 1 is assumed for this parameter. For other APs, the <period>
value is used for all the BSSIDs.
Sets the default primary WLAN <widx>
specified <type> (one of 802.11a, 802.11b, or 802.11b/g). The ESS ID
configured for this WLAN will be used in the 802.11a beacon as the primary
ESS.
Note: This parameter is used only for AP200 APs with 802.11a radios.
Sets the default basic and supported rates for radios of specified <type> (one
of 802.11a, 802.11b, or 802.11b/g). <basic> and <supported> must be a
comma separated list of rates, such as 6,9,11,15 with no spaces. Basic rates
are a subset of supported rates. The different types of radio support the
following rates.
A - 6|9|12|18|24|36|48|54
B - 1|2|5.5|11
G - 1|2|5.5|6|9|11|12|18|24|36|48|54
Note: For a G radio, basic rates must be a subset of B Rates in order to associate legacy
B stations.
Sets the default regulatory parameters for radios of specified type (one of
802.11a, 802.11b, or 802.11b/g), where <indoor> is one of
<ch> is the channel to use, and <pwr> is the power (in dB from
Select the value of <ch> from the appropriate list.
802.11b ch -- 1 to 14
802.11a ch -- 36,40,44,48,52,56,60,64,149,153,157,161
Note: Note: Regulatory parameter values depend on the country of operation and radio
type. Refer to the documentation for specific regulatory information.
Sets the default RTS threshold for radios of specified <type> (one of 802.11a,
802.11b, or 802.11b/g) to <bytes> (e.g., 2341).
(1 to 8) for 802.11a radios of
in or in/out;
4 to 20).