Set - Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual

3-12 WS2000 Wireless Switch System Reference Guide
3.2.9 Network AP set Commands

set

Network AP Commands
Sets Access Port parameters.
Syntax
set [beacon|ch_mode|div|dtim|loc|name|primary|rate|
reg|rts|short-pre|802.1x|ap_scan|mac|radio_type|
ap_type|sip_cac_mode|allowed_sip_session]
Parameters
beacon intvl
<idx> <interval>
ch_mode <idx>
[fixed|random|auto]
div <idx> <mode>
dtim <idx>
[<period>|<bss_idx
<period>]]
loc <idx> <loc>
name <idx> <name>
primary <idx> <widx>
rate <idx> <basic>
<supported>
reg <idx> <indoor> <ch>
<pwr>
rts <idx> <bytes>
Sets the beacon interval for Access Port <idx> (1–12) to <interval> in K-us (50–
200).
Sets the channel mode for Access Port <idx> (1–12) to fixed, random or auto.
Sets the default antenna diversity to <mode> (one of full, primary, or
secondary).
Sets the DTIM period for Access Port <idx> to <period> (number of beacons from
1–50).
<bss_idx> is the index of the BSSID. If not specified for the AP300, the default
value of 1 is assumed for this parameter. For other APs, the <period> value is
used for all the BSSIDs.
Sets Access Port <idx> location description to <loc>
Sets Access Port <idx> name to <name> (1–13 characters).
Sets the primary WLAN <widx> (the WLAN index from
associated with Access Port <idx> (1-12). The ESS ID configured for this WLAN
will be used in the 802.11a beacon as the primary ESS.
Note: This parameter is used only for AP200 APs with 802.11a radios
Sets Access Port <idx> (1-12) basic and supported rates. <basic> and
<supported> must be comma-separated lists of rates, such as 6,9,11,15 with
no spaces. Basic rates are a subset of supported rates. The different types of
radio support the following rates.
A - 6|9|12|18|24|36|48|54
B - 1|2|5.5|11
G - 1|2|5.5|6|9|11|12|18|24|36|48|54
Note: For a G radio, basic rates must be a subset of B Rates in order to associate legacy
B stations.
Sets Access Port <idx> (1-12)regulatory parameters, which <indoor> is one of
in or in/out; <ch> is the channel to use, and <pwr> is the power (in dB from
to 20). Select the value of <ch> from the appropriate list.
802.11b ch -- 1 to 14
802.11a ch -- 36,40,44,48,52,56,60,64,149,153,157,161
Note: Regulatory parameter values depend on country of operation and radio type. Refer
to documentation for regulatory information.
Sets the RTS threshold for Access Port <idx> (1-12) to <bytes> (e.g., 2341).
(1–13 characters).
1 to 8) for 802.11a radio
4