Rack Mounting The Hp Netserver; Introduction - HP D5970A - NetServer - LCII Installation Manual

8 Rack Mounting the HP NetServer

Introduction

This chapter provides the mounting instructions for the HP NetServer LXr 8500 in
a HP System/E or System/U rack. The illustration below shows the characteristics
of the System/E and System/U racks. If you are using the older HP Systems rack,
refer to Chapter 13 for instructions. If you are mounting the HP NetServer in a
non-HP rack, refer to the separate rack-mounting guide for third-party racks. It is
packed in the accessories tray in the HP NetServer's shipping box.
Figure 8-1. HP System/E and System/U Rack Features
a
b
Characteristics of
c
System/E and
System/U Racks:
a. 5-Cornered Columns
d
b. Full Panel Vent
c. "HP Rack System/E" or
"HP Rack System/U"
Name Plate
d. Numbered EIA Units
e. Anti-Tip Foot Extends
Out Front or Back
e
89