Tools Required - HP D5970A - NetServer - LCII Installation Manual

Chapter 8
NOTE If you want to put your HP NetServer into a third-party rack
not mentioned in the guide, you may be able to find relevant
documentation on HP's web site at the following URL:
http://www.hp.com/netserver/servsup
The HP NetServer rack mount kit requires 7 EIA units of space in the rack. Before
mounting the server, plan the HP NetServer's location in the rack relative to other
rack components. Proper placement is vital both for safety and operating
efficiency. For more details, see the Rack Installation Road Map and the HP
NetServer LXr 8500 Rack Assembly and Cabling Reference Guide.
NOTE If the HP NetServer is completely configured by the vendor
before delivery to the customer, then mounting the HP
NetServer in the rack may be the final step in the installation
procedure. If the vendor configures the HP NetServer at the
customer's site, installation of the network operating system
and other software may occur after the HP NetServer is
mounted in the rack.
WARNING The HP NetServer weighs over 155 pounds. To reduce weight,
and improve the NetServer's weight distribution during
installation, remove the HP NetServer's three power supplies
before lifting it.
CAUTION
If other rack components are to be mounted in the rack below
the HP NetServer, install those components before starting to
mount the NetServer.

Tools Required

To assemble the rack mount kit and install the HP NetServer on it, you need these
tools.
T-15, T-20, and T-25 Torx
Number 2 Phillips screwdriver
90
Rack Mounting the HP NetServer
®
Drivers