HP D5970A - NetServer - LCII Installation Manual page 171

Chapter 13
3. Insert the screws through the hinge into the three holes in the HP
NetServer and hand-tighten. See Figure 13-12.
Looking through the open side of the hinge, you can see three raised holes
for screws. These holes align with holes on the HP NetServer itself.
1. Insert screws into
holes through open
side of the hinge as
shown.
Figure 13-12. Fastening the Bezel Hinge to the Chassis
4. Use the access holes in the top of the hinge to insert a driver and finish
tightening the three screws. See Figure 13-12.
5. Attach the bezel latch to the HP NetServer with the screw.
See Figure 13-13.
The bezel latch should be in place when the HP NetServer ships, but this
step is provided if it is not installed or has come loose in shipping.
Alternative Rack Mounting
2. Tighten screws by
inserting driver
through access holes
in hinge as shown.
163