HP D5970A - NetServer - LCII Installation Manual page 53

Chapter 4
Filler
Panel
Figure 4-4. Removing the Peripheral Bay
10. Remove the two screws (Torx
bay and remove the cover. See Figure 4-5.
11. Remove the filler panel from the tape drive slot in the peripheral bay. See
Figure 4-5.
12. Remove the two mounting rails connected to the filler panel and save the
rails and screws. See Figure 4-5.
This may require a T-10 Torx
13. Remove the tape drive from the shipping container and its protective bag.
14. Remove the mounting bracket/hardware installed on the tape drive.
This may require a T-10 Torx
Installing Mass Storage Devices
Front of
NetServer
LCD Panel
Handle
Peripheral
Bay Assembly
Handle
®
T-15) holding the cover to the peripheral
®
driver instead of a T-15 driver.
®
driver instead of a T-15 driver.
Thumb
Screws (3)
Memory
Bay
Cover
45