HP D5970A - NetServer - LCII Installation Manual page 38

Chapter 3
Use anti-tip foot
Figure 3-2. Sliding Out the HP NetServer
®
6. Use a Torx T-25 screwdriver to remove the screws holding the HP
NetServer's flanges to the rack front columns.
CAUTION
To prevent damage to cables, or a disruption in service due to
a disconnection of cables, check for short cables at the rear of
HP NetServer and disconnect before proceeding.
7. Pull the HP NetServer out from the rack on its slides. See Figure 3-2.
8. Remove the two T-15 Torx
chassis. See Figure 3-3.
9. Slide the top cover to the rear approximately ½ inch. See Figure 3-3.
30
Opening and Closing the HP NetServer
Rack front columns
Use handle to
pull out NetServer
®
screws on the top cover, near the front of the
Flanges