HP D5970A - NetServer - LCII Installation Manual page 40

Hp netserver lxr 8500 installation guide
Hide thumbs Also See for D5970A - NetServer - LCII:
Table of Contents

Advertisement

Chapter 3
NOTE
After removing the top cover, a metal shield (embedded I/O
cover) blocks access to the I/O Riser board (it contains
connections for peripheral devices - keyboard, mouse, etc.). To
access the area under the I/O cover, lift off the I/O cover.
11. To access the area under the I/O cover, use two fingers to grip the finger
holes in the cover, and then lift it off.
12. To re-install the I/O cover into the I/O compartment at its location:
2
a. Insert the I
C cable in the cut-out opening in the top of the PCI slot
dividers as shown in Figure 3-5.
b. Align the left edge of the I/O cover with the PCI slot divider.
See Figure 3-5.
c. Insert the tabs, at both ends of the I/O cover, into the corresponding
slots at each end of the card cage and press down.
32
Opening and Closing the HP NetServer
Figure 3-4. Lifting Off the Cover
Embedded
I/O Cover

Advertisement

Table of Contents
loading

Table of Contents