Chapter 13
7. Insert the screws into the slides' holes to secure the chassis to the slides.
®
8. Use a Torx
T-20 driver to remove the screws holding the handles to the
HP NetServer. See Figure 13-9.
9. Take the handles off the HP NetServer and store the handles and screws in
a convenient place.
The handles can be re-attached whenever you remove the HP NetServer
from the rack. If moving the HP NetServer elsewhere, always package it
with the handles attached.
Figure 13-9. Removing the Mounting Handles
10. Press in the release latches on each slide, and push the HP NetServer all
the way back into the rack. See Figure 13-10.
The flanges on each side of the front of the HP NetServer must rest firmly
against the two front rack columns.
160
Alternative Rack Mounting