HP D5970A - NetServer - LCII Installation Manual page 37

Chapter 3
3. Press the power switch on the HP NetServer's control panel when
prompted by the operating system.
Normally, this completes the power down procedure.
NOTE
The power supplies will continue to provide standby current to
the HP NetServer until the power cable is disconnected.
WARNING Always disconnect the power cord before removing the top
cover, to avoid exposure to high energy levels that may cause
burns when parts are short-circuited by metal objects such as
tools or jewelry. Disconnect any telephone cables to avoid
exposure to shock hazard from telephone ringing voltages.
4. Remove the bezel from the front of the HP NetServer. See Figure 3-1.
Refer to "Removing and Replacing the Front Bezel."
5. At the front of the HP NetServer, extend the anti-tip foot out of the
installation rack. See Figure 3-2.
Opening and Closing the HP NetServer
29