HP D5970A - NetServer - LCII Installation Manual page 71

Chapter 6
NOTE
The HP NetServer can be configured to boot, by default, from
a PCI accessory board instead of the onboard SCSI channels,
by putting the board in slot P1. The NetServer can also be
configured to boot from a PCI-based DAC inserted into a PCI
slot in the I/O baseboard. The SCSI Configuration Utility can
be used to configure the NetServer to skip over the onboard
SCSI channels and select a different PCI slot, when scanning
for boot devices. For instructions, refer to the SCSI
Configuration Utility in Chapter 10, "Configuring the HP
NetServer."
Table 6-1. HP NetServer Boot Order (default)
Boot Order
5a.
5b.
5c.
6a.
6b.
6c.
10.
11.
12.
13.
14.
Component/Slot
1. IDE CD-ROM drive
2. Flexible disk drive
3. Slot P1
4. Slot P2
5. On-board SCSI (Channel A)
SCSI device ID 0
SCSI device ID 1
SCSI device ID 15
6. External SCSI (Channel B)
SCSI device ID 0
SCSI device ID 1
SCSI device ID 15
7. Slot P3
8. Slot P4
9. Slot P5
Slot P6
Slot P7
Slot P8
Slot P9
Slot P10
Installing Additional Boards
63