HP D5970A - NetServer - LCII Installation Manual page 79

Chapter 6
A. Push the
PCI hold-down
latch in from
the rear.
Figure 6-7. Closing the PCI Hold-Down Latch
NOTE
If the PCI hold-down latch does not fully close (click), the slot
will not be powered on when the HP NetServer reboots.
16. If the accessory board(s) installation is complete, install the PCI access
panel.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
CAUTION If the Cable Management Arm is not used, use caution when
sliding the chassis into the rack to prevent damage to cables.
17. Slide the chassis back into the rack.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
18. Re-install the bezel onto the front of the HP NetServer.
Installing Additional Boards
B. The latch
should click
into place.
C. Close the
latch on the
PCI board guide.
71